Technical Specifications; Table 2. Technical Specifications - Intel RS2WC080 Hardware User's Manual

Jumper
TP1
U1

Technical Specifications

I/O Processor Chip
Operating voltage
Card size
Array interface to host
SAS/SATA bus speed
SAS/SATA ports
Physical and virtual drive
support
Firmware
Compatible devices
Cabling
Redundant configuration
Enclosure management
Enclosure support
14
Type
4-pin connector
2-pin connector

Table 2. Technical Specifications

Specification
Universal Asynchronous
Receiver/Transmitter (UART)
Reserved for factory use
RAID Premium Feature Key header.
Enables support for RAID premium
feature.
®
Intel RAID Controller RS2WC080
LSI*SAS2008 PCI* Express-SAS/SATA I/O Processor chip,
150MHz
+3.3 V, +12 V
Low profile, extended half-length (6.6" x 2.731")
PCI Express* Revision 2.0, x8 lane width 5.0 Gb/s
Up to 6 Gb/s per port, point-to-point
2x4 internal ports, up to 64 devices with expanders
Up to 64 physical drives including up to 16 physical drives in
up to 16 RAID arrays per controller
Drives not configured as part of a RAID array can be
configured as "pass through" drives in Non-RAID mode.
Up to 16 MB in reflashable flash ROM
•
2.5-inch and 3.5-inch SAS or SATA II drives including SSD
drives
•
Non disk devices including expanders
•
Can support drives of mixed capacity
•
Small, thin cables that do not restrict airflow
•
Shared connectors for multiple drives
32 KB NVRAM and config-on-disk (COD)
•
In-band SES
•
SGPIO
Assumes one SEP per enclosure
Intel® RAID Controller RS2BWC080 Hardware User's Guide
Description