Using The Sleep Timer; Setting The Display Brightness; Displaying Source Information - Onkyo TX-NR414 Instruction Manual

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator lights on the AV receiver's
display when the sleep timer has been set. The
specified sleep time appears for about 5 seconds, then
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps,
press SLEEP. Note that if you press again on SLEEP as
the time being displayed is 10 minutes or less, the sleep
timer will go off.

Setting the Display Brightness

You can adjust the brightness of the AV receiver's display.
1
Press RECEIVER once followed by DIMMER
repeatedly to switch between: normal, dim, or
dimmer brightness.
Tip
• (North American and Taiwanese models) Alternatively,
you can use the AV receiver's DIMMER.
En-36
Turning On & Basic Operations

Displaying Source Information

You can display various information about the current
input source as follows.
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use the AV receiver's DISPLAY.
The following information can be typically displayed.
Input source
& volume *1
Listening
mode
Signal
format *2
Sampling
frequency *2
*1
When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then the
previously displayed information reappears.