Advanced Recording; Fade-In And Fade-Out Recording; Synchronized Recording; Sync Recording - Tascam CD-RW901SL Owner's Manual

5 − Recording
IMPORTANT SAFETY PRECAUTIONS

Advanced recording

Fade-in and fade-out recording

At the beginning and end of recording, fade-in and fade-
out effects can be performed.
1. When stopped or when in recording standby mode,
set the operation using the following menu options
on the REC sub-menu (see "Operation basics" on
page 16).
FADE IN?
The length of the fade in to the normal level can be
set between 1 and 30 seconds in 1-second increments
(default setting: 3 seconds).
FADE OUT?
The length of the fade out into complete silence can be
set between 1 and 30 seconds in 1-second incre-ments
(default setting: 3 seconds).
The display shows
F a d e O u t > X X s

Synchronized recording

Synchronized recording basically means that recording
will begin automatically when a signal is received, and will
stop when the signal ends.
The SYNC indicator appears on the display.

Sync recording

1. While recording standby mode, press the
REC key.
2. Set the signal detection threshold level. Use the
SYNC LEVEL option in the REC sub-menu (see
"Operation basics" on page 16).
Rotate the MULTI JOG
level can be set from -72 dB to -24 dB in 6 dB incre-
ments. The default setting is -54 dB.
Press the MENU key or push the
enter and return to recording standby mode.
3. Input the source signal.
Recording begins automatically when the source
signal is detected. The source signal should be high-
er than the adjusted threshold level.
level
Start of recording
S_LVL
Noise level
NOTE
After SYNC is set, over one second of silence which is
under the adjusted threshold level is required to start
 
TASCAM CD-RW901SL TASCAM CD-RW901SL
or
F a d e I n > X X s
SYNC
dial to adjust the level. The
MULTI JOG dial to
time
2. In recording standby mode, press the
on the remote control.
Recording begins and the sound fades in. After the
preset fade-in time, the sound is at normal level.
3. During recording, press the
remote control when you wish to fade-out the sound.
Fade-out begins with Fade Out flashing on the
display then the unit enters recording standby mode.
4. Press the STOP
NOTE
Fade-in or fade-out function can be operated only by
pressing the FADER key on the remote control unit.
.
Starting playback of the source automatically starts record-
ing on the CD-RW901SL if Sync function is on (see "Sync
recording" below) and manual record start is disabled.
recording automatically. Otherwise, the unit does not
begin recording even if it is detecting a signal.
When audio signal is not detected for more than five
seconds, the CD-RW901SL automatically will stop record-
ing and enter record standby mode.
level
S_LVL
NOTE
When the input level drops below the adjusted thresh-
old level for more than five seconds, recording stops
automatically and enters in recording ready mode.
3. To cancel the Sync recording mode, press the
key. Recording returns to normal and
SYNC REC
continues till you press the
signal stops.
Pressing the STOP
The setting remains when the function is set on again.
FADER
FADER key on the
key and the PMA writing will begin.
REC ready
Five seconds
time
key or the source
STOP
key stops recording.
key