BENDIX C-5 CUT OUT COCK Manual

®
® ™
Bendix C-5 Cut-Out Cock
FIGURE 1
DESCRIPTION
The C-5 ™ cut-out cock is a manually operated on-off valve.
Cut-out cocks are used in an air brake system where a
manual shut off air lines is desirable such as in trailer and
trailer dolly systems.
OPERATION
Note that in Figure 1 the C-5
ball valve between two valve seats. Rotating the ball valve
90° will either open or close the air passage through the
cut-out cock.
PREVENTIVE MAINTENANCE
Every six months, 1800 operating hours, or 50,000 miles
the cut-out cock should be checked for leakage around the
ball valve and past the stem o-ring. Once each year, 3600
hours, or 100,000 miles the C-5
disassembled, cleaned, and inspected for signs of wear or
deterioration.
OPERATING HANDLE
CAP NUT
REDUCER
BUSHING
O-RING
™ cut-out cock uses a metal
™
cut-out cock should be
LOCK NUT
O-RING
VALVE SEATS VALVE
BODY
LEAKAGE CHECK
With the valve in the closed position and air pressure present
on either side, a soap solution is applied to the side open to
atmosphere. A leakage of not more than a 1" bubble in 5
seconds is permitted.
NOTE: Leakage should be checked in each direction since
it is possible for the valve to seal in one direction
but not the other.
If the cut-out cock leaks excessively or if wear or deterioration
is noted during routine maintenance, it is recommended that
it be replaced with a new unit or repaired with genuine Bendix
parts.
REMOVING AND INSTALLING
REMOVING
Block and hold vehicle by means other than air brakes.
Completely drain all reservoirs. Disconnect air lines from
both sides of the cut-out cock.
STEM
STEM
WASHER
CLAMPING
STUD
1