Comfort Glow CGD3924NT, CGD3930NT, CGD3018NT, CGB3924NT, CGB3930NT, CCL3018NT, CCL3924NT, CCL3930NT Owner's Operation And Installation Manual page 15

INSTALLATION
Continued
Dual Burner Premium Aged
Split Oak Models
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 22). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner "U" bend.
2. Locate pegs on the bottom of back log
(#2). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 23).
3. Place crossover log (#3) onto the pin (right)
on middle log (#1) and into the recess of
the back log (#2). See Figure 24.
Middle Log (#1)
Tab
Burner
Figure 22 - Installing Middle Log (#1)
107123
4. Locate the notches in the bottom of the
front log (#4). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers. See Figure 25.
5. With knot to right side, place smaller
log piece (#5) over the pin on the left
side of the middle log. The smaller log
will rest on front log against the "knot"
on the left. See Figure 26.
6. Place lava rock around base of heater.
Do not put lava rock on logs on burner.
Hole in
Grate Base
Burner
Figure 23 - Installing Back Log (#2)
"U" Bend
U-Shaped
Slot
Figure 24 - Installing Crossover Log (#3)
OWNER'S MANUAL
Back Log (#2)
Peg
Crossover Log
(#3)
Recess
Peg
For more information, visit www.desatech.com
15
Front Log (#4)
Grate Fingers
Figure 25 - Installing Front Log (#4)
Log Piece (#5)
Peg
Figure 26 - Installing Log Piece (#5)
Notches
Continued