Creative SB0060 - Sound Blaster Live User Manual page 98

D-4 Troubleshooting
The Original Sound sliders in either the Master and Source tabbed pages of the Environmental
Audio applet are set at or near 0%.
Check the following:
The speakers' volume control knob, if any, is set at mid-range. Use Creative Mixer to adjust
the volume, if necessary.
The powered speakers or external amplifier are connected to the card's Line Out or Rear Out
jack.
No hardware conflict between the card and a peripheral device. See "Resolving I/O Conflicts"
on page D-7.
The Speakers selection in the Environment deck of Surround Mixer corresponds to your
speaker or headphone configuration.
The Original Sound sliders in either or both the Master and Source tabbed pages of the
Environmental Audio applet are set to 100%.
No audio output when playing CD-Audio.
OR
No audio output when playing DOS games that require a CD-ROM.
To solve this problem:
• Make sure the Analog Audio connector on the CD-ROM drive and the CD In connector on
the audio card are connected.