Sharp GX30 Service Manual page 80

(A4) x 2
1.7 x 5 mm
PULL
External Connector Cover
(A5) x 2
2
SLIDE
1
UP
3
SWING
Front Cabinet (Key)
Jig
(Use something flat and hard,
for example guitar picks.)
1 Remove the external connector cover.
Insert a jig into the slot and slightly lift up the back cabinet (key) assembly.
2
Insert jigs into the space.
Slide jigs on the both sides to release 4 hooks (A5).
3 Move the cabinet assembly gently from side to side
to release the other hook (A6).
(A1) x 1
(A2) x 1
(A3) x 2
(A4) x 2
1.7 x 5 mm
PUSH
Back Cabinet (Key)
Assembly
Back Cabinet (Key) Assembly
(A6) x 1
(A5) x 2
2
SLIDE
Back Cabinet (Key)
Assembly
Open the SD card cover and turn it as indicated by the arrow to release the stopper.
Then pull out the cover downward.
Remove the SD cover belt as instructed below.
SD Card Cover
1
(B2) x 4
2
3
4
Aerial
1 PUSH
(C1) x 1
Back Cabinet
(Key) Assembly
(B1) x 1
SD Card Cover Unit
SD Card Cover Belt
2 PULL
(C2) x 1