Desa VDCFTNB Owner's Operation And Installation Manual page 25

OPERATING FIREPLACE
Continued
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 40). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 23.
1. After lighting, let pilot flame burn for
about one minute. Turn control knob to
ON position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the
selector switch to the REMOTE position
(see Figure 41). Note: The burner may light
if hand-held remote was on when selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the
pilot is not lit. This will drain the battery.
Flame
Adjustment Knob
Selector Switch in Remote
Position (Optional Remote Control)
Figure 41 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 42).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together on
hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
116526-01A
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 43). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Control
Knob
www.desatech.com 25