Remote Control; Remote Control Basics; Changing The Batteries - JVC AV-27F703 - 27" Real Flat TV User Manual

TV CATV VCR DVD 16:9
MODE
PIP
EZ SURF CHANNEL
INPUT SOURCE FREEZE
DISPLAY 1 2
SLEEP TIMER 4 5
HYPER SUR. 7 8
0
100+
VIDEO STATUS
BBE
THEATER PRO
RM-C325G
MUTING
+
CH
VOL
VOL
C H
MENU
VCR/DVD
VCR CHANNEL
POWER
PREV NEXT
REW PLAY
STOP PAUSE
REC
OPEN/CLOSE STILL/PAUSE
TV

Changing the Batteries

Push down on the remote's back cover and slide towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the "+" and "–" markings on the batteries
and on the remote control. To avoid a potential short circuit, insert the "–" end first. Be sure to
use only size AA batteries.
When batteries are installed, slide the cover back into place (until it clicks into position).
• If the remote control acts erratically, replace the batteries. Typical battery life is six months to
one year. We recommend using alkaline batteries for longer battery life.
When you change the batteries, try to complete the task within three minutes. If you take
longer than three minutes, the remote control codes for your VCR, DVD, and/or Cable
Box may have to be reset (see page 20-22).

Remote Control Basics

• Before you can operate the remote control, you must first
POWER
install the batteries (included). See "Changing the Batteries"
at the bottom of this page for instructions. (For an illustration,
ON/MOVE
please see page 10.)
• Press the P
SWAP
• Make sure the TV/CATV switch is set to TV. Move the switch
3
to CATV only if you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR,
6
slide to DVD to control a DVD player. Please see pages 20
9
to 22 for instructions on programming your remote control to
operate a Cable box, VCR or DVD player.
RETURN+
• Press the CH+ and CH- buttons to scan through the chan-
nels. Tap the CH+ or CH- button to move through the chan-
LIGHT
nels one channel at a time.
• To move rapidly through the channels using JVC's
Hyperscan feature, press and hold CH+ or CH-. The chan-
V CHIP
nels will zip by at a rate of five channels per second.
• Press V
+
tor bar will appear onscreen to show you the television vol-
EXIT
ume level.
• The CH+/- and V
PIP OFF
JVC's onscreen menu system.
• You can directly access specific channels using the 10-key
TV/VCR
pad.
FF
• For more information on remote control button features, see
pages 43 to 46. For information on using the onscreen
menus, see page 24.
Notes: Remote control model RM-C325G is shown at the left.
A different model remote control may have come with your
television.

Remote Control

button to turn the television on or off.
OWER
+ or V - to raise or lower the volume. An indica-
OL OL
+/- buttons are also used to navigate
OL
19