Release Shutter - Nikon F65 - F65 35mm SLR Camera Body Only Instruction Manual

4

Release Shutter

Confirm that (in-focus indicator) appears in the viewfinder, then slowly,
fully depress the shutter release button. With a moving subject,
Continuous Servo AF (page 44) activates and camera continuously
focuses on the subject.
1
2
32
Confirm indications in the
viewfinder while lightly pressing
the shutter release button.
• When the subject is dark or backlit and
shutter release button is lightly pressed, the
built-in Speedlight automatically pops up
and starts charging (pages 34, 76).
Confirm that focus indicator
appears and slowly depress the
shutter release button.
• After the shutter is released, the film
automatically advances to the next frame
and the next shot can be taken.
3 Film starts to rewind automatically when
film reaches the end of the roll.
• The frame counter counts down until rewind is
complete.
• Pictures taken on frames beyond the indicated
number of the exposures for the film roll may be
discarded in the process of developing.
4 Confirm that film is completely rewound,
then remove film cartridge.
• Film is completely rewound when the frame counter
shows blinking
without blinking when the exposure meter is off.)
Make sure the film is completely rewound ( is
blinking in the LCD panel), open the camera back
away from sunlight and remove the film cartridge
by tilting it to one side.
Check points
• If any other warning indications appear, see page 99.
• For mid-roll rewind, see page 66.
in the LCD panel. ( appears
33