Desa Tudor CGDV32PR Owner's Operation And Installation Manual page 25

FIREplaCE
INSTallaTION
Continued
9. Follow instructions below to install logs, lava
rock and ember material.
10. Close glass door, lock latches on top and bottom
of door and replace screen (see steps 5 and 6 of
Removing Glass Door, page 24).
11. Close top and bottom louvers.
Left Side
Brick Panel
Figure 44 - Installing Side Brick Panels
INSTALLING LOGS, LAVA ROCK
AND GLOWING EMbERS
Each log is marked with a number. These numbers
will help you identify the log when installing. It
is very important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches
and open glass door. See steps 1 and 2 of Remov-
ing Glass Door, page 24. Install logs according to
instructions for fireplace model numbers.
1. Place log #1 (rear log) on top of grate. Make
sure the notches in the bottom of the log fit
over the grate (see Figure 45).
2. Rest log #2 (large front log) on the pins on the
front part of the grate (see Figure 46).
3. Place log #3 (crossover log) onto the rear and
front logs. Make sure it is seated properly on
the smooth surface on the front log and on the
pin on the back log as shown in Figure 47.
4. Place log #4 (right log) on the pin on the
right side of front log as shown in Figure
48, page 26.
5. Place log #5 (base log) onto the front left part
of the grate making sure the notches fit over the
prongs of the grate). See Figure 49, page 26.
116646-01D
Figure 45 - Installing Log No. 1
Figure 46 - Installing Log No. 2
Figure 47 - Installing Log No. 3
www.desatech.com 5