Tightening Torques For Pressure Senders - VDO SENSORS - INSTRUMENTATION V3.0 Manual

Tightening Torques for Pressure Senders

Tightening Toraques for Pressure Senders
Tightening Torques for
Pressure Senders
The values given in the following table for
maximum tightening torque are exclusively based
on the load capacity of the pressure sender
(Nm max. Sender).
22
Nm max.
M10 x 1.0 30 Nm
1/8 in. BSPF 30 Nm
1/8 – 27 NPTF 30 Nm
R 1/8 DIN 2999 30 Nm
M12 x 1.5 40 Nm
M12 x 1.0 50 Nm
M14 x 1.5 60 Nm
1/4 in. BSPF 60 Nm
1/4 – 18 NPTF 60 Nm
3/8 – 18 NPTF 60 Nm
M16 x 1.5 80 Nm
3/8 – 18 Dryseal NPTF 80 Nm
M18 x 1.5 100 Nm
Prior to using the pressure sender, it is important
to ask the relevant manufacturer of the vehicle,
equipment system or engine for the maximum
torque value of the threaded hole into which
the pressure sender is to be screwed (Nm max.
Installation Area).
Non-observance of the maximum tightening
torque specified for the respective threaded hole
can result in damage to the vehicle, engine or
equipment system.
Sender