Front Panel - American Audio VX User Instructions

Front Panel

VX1000
VX1500
VX2500
1. Channel Signal Indicators - These green and yellow Led's will glow
according to the average signal output.
2. Channel Protect Indicator - The red protect Led will begin to glow
when the channel goes into protect mode. When the channel goes into
protect mode all output for that channel will turn off. This is to protect any
speakers connected to the channel.
3. Power Switch - This switch is used to control the units main power.
4. LCd Screen - This Lcd screen lets you know the current tempera-
tures of both channels. it also will display the different menus and set-
tings when accessed using the menu and enter buttons.
5. Channel Limiter Indicator - This red LED will begin to flash when the
respective channel begins to overload (clip). At this point channel one will
begin to distort. under heavy clipping activity lower the channels gain
control to reduce the risk of damage to your speakers and amplifier. This
Led may glow when the unit has been turned off, this is normal.
6. Channel B gain Control - This rotary knob is used to control the
output signal of channel B. Turning the knob in a clockwise direction will
increase signal output.
7. enter Button - This button will allow you to access the different set-
tings located in the menu. push this button to set your desired setting.
8. down Button - This button allows you to scroll backwards when in
the menu settings.
9. Up Button - This button allows you to scroll forwards when in the
©American Audio® - www.americanaudio.com - VX Series™ Power Amplifier User Manual Page 5
1 2 3 4
10
12 11 9 8 7
menu settings.
10. Menu Button - This button, when pushed, lets you access the amp
menu. continue to push to scroll through the menu choices
11. Function Indicators - These indicators detail the operating mode of
the amplifier. This blue LED will also function as a power indicator.
12. Channel a gain Control - This rotary knob is used to control the
output signal of channel A. Turning the knob in a clockwise direction will
increase signal output.
5
6
Figure 1