American Audio VLP 2500 User Instructions

American Audio VLP 2500 User Instructions

Professional power amplifier
Hide thumbs Also See for VLP 2500:

Advertisement

AmericAn Audio
®
6122 S. eastern Ave.
Los Angeles ca. 90040
rev. 3/10
VLP 2500

User Instructions

Professional Power Amplifier

Advertisement

Table of Contents
loading

Summary of Contents for American Audio VLP 2500

  • Page 1: User Instructions

    Professional Power Amplifier VLP 2500 AmericAn Audio ® User Instructions 6122 S. eastern Ave. Los Angeles ca. 90040 rev. 3/10...
  • Page 2 Reparaturen nur von qualifizierte Fachpersonal durchführen lassen. aChtUng: Um einen elektrischen Schlag oder Feuergefahr zu vermeiden, sollte diesen Gerät nicht dem Regen oder Feuchtigkeit ausgesetz werden. Vor Inbetriebnahme unbedingt die Bedienungsanleitung lesen. ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 2...
  • Page 3: Table Of Contents

    Front Panel........................................5 rear panel........................................6 inputs...........................................7 outputs..........................................7 Speakon output connector Assembly...............................9 operating modes......................................10 protection circuitry Limiter.........................................11 Short circuit protection...................................11 Thermal protection..................................12 Amplifier Features.......................................12 Speaker Setup......................................13 Warranty.........................................14 Specifications.......................................15 ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 3...
  • Page 4: Safety Precautions

    C. The appliance has been exposed to rain or water. Fax: (323) 582-2941 D. The fixture does not appear to operate normally or exhibits a marked change in performance. ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 4...
  • Page 5: Front Panel

    8. Channel 2 Clip Indicator - This red LED will begin to flash when channel one begins to overload (clip). At this point channel one will be- gin to distort. under heavy clipping activity lower the channel one gain ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 5...
  • Page 6: Rear Panel

    Audio® service technician. 29. aC Cord - plug this cable into a standard wall outlet. check that the voltage in your area matches the amplifiers required voltage. ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 6...
  • Page 7: Inputs

    Up InpUts - The vLp 2500 amplifier allows you to use two types of input connector per a channel, a XLr jack for balanced connections and a 1/4” female jack that will accept balanced and unbalanced connectors. use these connections to connect the output signal from a mixer, cross-over or EQ to your VLP 2500 amplifier.
  • Page 8 You can purchase the Speakon NL4FC connectors from your local audio dealer. ® ©American Audio® - www.americanaudio.us - VLP 2500 Power Amplifier User Manual Page 8...
  • Page 9: Speakon Output Connector Assembly

    CAUTION SPEAKON 1+ HOT 1 COLD MINIMUM LOAD IMPEDANCE 2 OHM PERCHANNEL 4 OHM BRIDGE - B I D E + UTPUTS 120 60 4800 A TTS ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 9...
  • Page 10: Operating Modes

    This mode is recommended when using the vLp 2500 to run bass speakers, to achieve better low end.
  • Page 11: Limiter

    Limiter - The VLP 2500 comes with a built in limiter. When the input signal overloads, the “CLIP LED’s” indicate a signal overload, at this time, the master volume should be lowered to reduce distortion. if the input gain level is not reduced the built-in limiter will acti- vate.
  • Page 12: Thermal Protection

    Protection - dual variable speed fans on the vLp 2500 amplifier provide adequate cooling. during low level output the fans run at normal speeds.
  • Page 13: Speaker Setup

    Mono brIDge set-Up use channel 1 inputs only (XLr or 1/4” Jacks) Figure 14 use the two positive binding post termainals (red) for speaker output. speaKers 8 OHM MINIMUM ©American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 13...
  • Page 14: Warranty

    C. This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which American Audio® con- cludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the American Audio®...
  • Page 15: Specifications

    Damping Factor @ + 450 8 Ohm: Impedance: 20K Ohms Balanced 10K Ohms Unbalanced Dimensions 17.8” x 19” x 3.5” (LxWxH): 453 x 482 x 88mm Weight: 49.8lbs/22.6Kgs American Audio® - www.americanaudio.us - vLp 2500 power Amplifier user manual page 15...
  • Page 16 ©American Audio® World Headquarters: 6122 S. eastern Ave. Los Angeles, cA 90040 uSA Tel: 323-582-3322 Fax: 323-725-6100 Web: www.AmericanAudio.us E-mail: info@americanaudio.us American dJ europe Junostraat 2 6468 EW Kerkrade netherlands service@americandj.eu / www.americandj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99...

Table of Contents