Running Acronis True Image Management Console; Running Other Acronis Components; Removing Acronis True Image Echo Workstation Components - ACRONIS TRUE IMAGE ECHO - WORKSTATION User Manual

Table of Contents

True Image Echo Workstation will be run in the standalone mode, allowing you to recover

the damaged partitions.

If your disk data is totally corrupted and you cannot boot (or if you have not activated

Acronis Startup Recovery Manager), load the standalone Acronis True Image Echo

Workstation version from the bootable media (created by you using Rescue Media

Builder) or RIS-server. Then you will be able to restore the disk from a previously created

image.

2.5.2 Running Acronis True Image Management Console

To run Acronis True Image Management Console, select Start -> Programs -> Acronis

-> Acronis True Image Management Console -> Acronis True Image

Management Console.

Acronis True Image Agents, Acronis Backup Server and Acronis Group Server run as

services immediately after installation and the consequent system reboot (if the latter is

required). Later on they will automatically launch at every system restart. You can stop

and start these programs in the same way as other services.

You can remove any Acronis True Image Echo Workstation component separately by

selecting Control panel -> Add or remove programs -> <The component name>

-> Remove. Then follow instructions on the screen. You may have to reboot your

computer afterwards to complete the task.

In case you remove Acronis True Image Agent or Acronis True Image Echo Workstation

local version from the system, there is an option to keep the Acronis Secure Zone along

with its contents (which will enable data recovery on booting from bootable media) or

remove Acronis Secure Zone.

Table of Contents

True image echo