Selecting A Partition To Restore; Selecting A Location To Restore To - ACRONIS TRUE IMAGE SERVER 7.0 User Manual

Acronis True Image Server User's Guide
If you are to restore an image from removable media, e.g. CD, first insert the latest burnt CD
and then insert them in order starting from the one created first.
If you provided a comment to the image, it would help you understand if you
selected the right image. The comment is displayed in the right part of the window.
Note that it can be seen without entering a password for a protected image.
However, the contents of such image will still require a password.
If an image was protected with a password, Acronis True Image Server will ask for
it. In this case the Next button will be disabled until you enter the right password.
If you are to restore a disk (partition) from an incremental image, you must have the current
image as well as at least one or even all previous incremental images and the initial full image.
The exact number of images depends on how disk contents changed between image creation
procedures.

Selecting a partition to restore

A single file might contain images of several partitions or even disks, as shown in
the figure below.
Select a partition to restore
During a single restoration session you can restore several partitions or disks one by
one by selecting one disk and setting its parameters first, and then repeating these
actions for every partition or disk to be restored.
Select the necessary partition and click Next.

Selecting a location to restore to

As a rule you should restore image to the same partition that the image was created
from.
Restoring a disk (partition) from an image