Specific Options (Options Specific For Individual Trueimagecmd Commands) - ACRONIS TRUE IMAGE 9.1 User Manual

/compression:[0...9]
/split:[size in MB]
General options
/oss_numbers
/reboot
/log:[file name]
15.1.3 Specific options (options specific for individual trueimagecmd
commands)
Option
create
/harddisk:[disk number]
/partition:[partition
number]
/file_partition:[partition
letter]
Copyright © Acronis, Inc., 2000-2007
Specify the data compression level.
It ranges from 0 to 9 and is set to 3
by default
Split the backup into parts of the
specified size
Declares that numbers of partitions
in the
/partition
adjusted for MBR partition table
rather than be simple ascending
numbers. This means that primary
partitions have numbers 1-1, 1-2, 1-
3 (and 1-4 if there are not logical
partitions on the disk) and logical
partitions numbers start with 1-4.
For example, if the disk has one
primary and two logical partitions,
their numbers
follows:
/partition:1-1,1-2,1-3
/oss_numbers /partition:1-1,1-
4,1-5
Reboot the
operation is completed
Create a log file of the current
operation with the specified file
name
Description
Specifies the hard disks to include into the image file by numbers.
The list of available hard disks is provided by the
An image may contain data of more than one hard disk. In that
case, separate disk numbers by commas, e.g.:
/harddisk:1,3
Specifies the partitions to include into the image file by numbers.
The list of available partitions is provided by
numbers are specified as <disk number>-<partition number>, e.g.:
/partition:1-1,1-2,3-1
Dynamic volumes are specified by letters, e.g.:
/partition:C,E
Specifies the partition where the image file will be stored (by letter
or number). This option is used with
that case the file name must be specified without drive letter or root
folder. For example:
/file_partition:D /filename:"\1.tib"
option are
can appear as
or
server after the
/filename:[file_name]
Any
Other than ASZ
Any
Any
Any
command.
/list
. Partition
/list
. In
107