ACRONIS TRUE IMAGE 9.0 - HOME User Manual page 78

F1 Help ↓
Esc Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
Place the marker on the value of the Type parameter ([Auto] in this case) and press
the Enter key to open the list of possible values of this parameter; for example:
None
Auto
User Type HDD
CD-ROM
LS-120
ZIP-100
MO
Other ATAPI Device
Use the Up and Down keys to select the User Type HDD value and press the Enter
key to get to the following screen:
Main
Primary Master [User Type HDD]
Type
Translation Mode
Cylinders
Head
Sector
CHS Capacity
Maximum LBA Capacity 0MB
Multi Sector Transfer
SMART Monitoring
PIO Mode
Ultra DMA Mode
F1 Help ↓
Esc Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
Enter the values of Translation Mode, Cylinders, Head and Sector parameters (you
can find them on the case of the hard disk) to finish the initial configuration of the
hard disk with BIOS.
Translation Mode parameter can have the following values:
LBA
Large
Normal
Match Partition Table
Manual
New versions of AwardBIOS menu have the Boot item. The screen of the Boot
menu, which is responsible for adjusting the boot sequence, looks like this:
Main Advanced
1. ATAPI CD-ROM
78
Select Item -/+ Change Values
AwardBIOS Setup Utility
[User Type HDD]
[LBA]
[.........0]
[......0]
[...0]
0MB
[Maximum]
[Disabled]
[4]
[5]
Select Item -/+ Change Values
AwardBIOS Setup Utility
Power Boot
[None]
Shielded 80-pin cable.
F5 Setup Defaults
Item Specific Help:
<Enter> to select the type
of the IDE drive.
[User Type HDD] allows
you to set each entry on
your own.
Warning: Ultra DMA Mode
3/4/5 can be enabled only
when BIOS detects
Shielded 80-pin cable.
F5 Setup Defaults
Exit
Boot Sequence:
Copyright © Acronis, Inc., 2000-2006