Replacing A Power Supply - Dell PowerVault TL2000 User Manual

Configuring the Tape Drive
1. Log on to the Web User Interface.
2. Verify that you are running the latest version of Library firmware and drive
3. Use the Web UI to update the Logical Library (Configure Library → Logical
4. Reconfigure your library using the OCP to configure your network settings,
5. Save your library configuration to your host computer or to a USB device.
6. Update your Library Configuration Form with the new drive and configuration
7. Resume normal library operations.

Replacing a Power Supply

10-10
Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide
firmware (library firmware: Monitor Library → Library Identity; drive
firmware: Monitor Library → Drive Identity). Upgrade, if necessary (Service
Library → Upgrade Firmware).
Libraries) and Drive (Configure Library → Drives) configurations. Refer to
Chapter 5, "Operations," on page 5-1. Select Submit on the Configure Library
→ Logical Libraries web page even if there are no required changes. This action
will refresh the Data Transfer Element (DTE) for the drives. Refer to
Appendix A, "SCSI Element Types, SCSI Addresses, and Physical
Configurations," on page A-1 for information regarding DTE addressing. If
Configure Library → Logical Libraries does not correctly refresh/update the
DTE addresses, execute step 3 and step 4. Otherwise, proceed to Step 5.
then using the Web UI to complete your library configuration.
information.
1. Power OFF the library by pressing and holding down the power button for 4
seconds.
2. Disconnect the power cord from the electrical source, then from the library.
3. Loosen the three blue captive thumbscrews on the power supply located on
the back panel of the library.
4. Pull on two of the thumbscrews to pull the unit away from the rear panel of
the library, then grasp the top and bottom edge of the power supply and pull
it out of the library.