Step 7: Connect To The Target Storage Array From The Host Server - Dell PowerVault MD3600i Deployment Manual

7 Select one:
• If you are not using CHAP authentication, select No Authentication.
Go to step 8.
or
• If you are using CHAP authentication, enter the CHAP user name and
password. To enable Mutual CHAP, select and enter the Mutual
CHAP user name and password.
8 Repeat step 7 for each target until at least one connection is logged in for
each controller.
9 Go to Connected Targets.
10 Verify that the targets are connected and displays a status of true.
Step 7: Connect to the Target Storage Array From
the Host Server
If you are using Windows Server 2008 GUI:
1 Click Start Programs Microsoft iSCSI Initiator or click Start All
Programs Administrative Tools iSCSI Initiator.
2 Click the Targets tab.
If previous target discovery was successful, the iqn of the storage array
should be displayed under Targets.
3 Click Log On.
4 Select Automatically restore this connection when the system boots.
5 Select Enable multi-path.
6 Click Advanced and configure the following settings under the General
tab:
Local Adapter—Must be set to Microsoft iSCSI Initiator.
•
Source IP—The source IP address of the host server you want to
•
connect from.
• Target Portal—Select the iSCSI port on the storage array controller
that you want to connect to.
Appendix—Manual Configuration of iSCSI
73