Security
SmartCard SystemLock
SmartCard SystemLock
Uninstall:
BIOS Recovery:
SmartCard and Pin
SmartCard Initialization
Admin SmartCard
SuperUser SmartCard:
User SmartCard:
Service SmartCard:
SmartCard Configuration
Change PIN:
Change PUK:
Unblock SmartCard:
The other SmartCards should either be generated as User SmartCards (System) or as
extended User SmartCards (System and Setup). These then have a
restricted access to the device (see chapter "Uninstall SystemLock").
►
Select the required function. The following prompt will be displayed:
Remove your Admin Card.
Keep the Admin SmartCard in a safe place and
i
protect it from unauthorised access.
►
Remove the Admin SmartCard.
Insert a SmartCard.
►
Insert the next SmartCard and initialise this as required.
The following prompt will be displayed:
Remove the SmartCard.
Always change the PIN and PUK for each additional SmartCard. The PUK
i
of a SmartCard will be needed if a blocked SmartCard
needs to be unblocked using the Unblock SmartCard function.
►
Remove the user SmartCard and label it, e.g. with the name of the user. But NEVER write the
PIN on the SmartCard under any circumstances!
A26391-K276-Z226-1-7619, edition 2
Installed
[Enter]
[Allowed]
[Always required]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
[Enter]
Security functions
Item Specific Help
Allows to deactivate
The smartcard security.
ATTENTION:
Always check the BIOS
password settings after
uninstalling
SystemLock.
NOTICE:
Reinstalling a SinglePC
implies re-initializing
all of your smartcards
85