Show Enclosure-Status; Show Events; Show Expander-Status; Show Frus - HP 2000fc Cli Reference Manual

show enclosure-status

Shows the status of system enclosures and their components. For each attached
enclosure, the command shows general SCSI Enclosure Services (SES) information
followed by component-specific information.
For details see "show enclosure-status" on page 178.

show events

Shows events for an enclosure, including events from each Management Controller
and each Storage Controller. A separate set of event numbers is maintained for each
controller module. Each event number is prefixed with a letter identifying the
controller module that logged the event.
If SNMP is configured, events can be sent to SNMP traps.
For details see "show events" on page 181.

show expander-status

Note –
advice of a service technician.
Shows diagnostic information relating to SAS Expander Controller physical
channels, known as PHY lanes. For each enclosure, this command shows status
information for PHYs in I/O module A and then I/O module B.
For details see "show expander-status" on page 184.

show frus

Shows information for all field-replaceable units (FRUs) in the controller enclosure
and in any attached drive enclosures. Some information reported is for use by
service technicians.
For details "show frus" on page 186.
This command should only be used by service technicians, or with the
Chapter 4 Troubleshooting Using the CLI 257