Audio I/O Connection; Analog Audio Connection ([In] And [Out] Connectors) (Dme24N Only) - Yamaha DME64N - Pro Audio Owner's Manual

Audio I/O Connection

Analog Audio Connection ([IN] and [OUT] Connectors) (DME24N only)

The DME24N includes [IN] and [OUT] connectors for 8 channels of analog audio input and output. Wire
the supplied Euroblock plugs as shown below. Head amplifier gain and phantom power settings can be made
via the Utility display HA page described on page 54 of this manual, or via the DME Designer application.
Euroblock Connection
N OT E
A slotted screwdriver with a blade width of about 3 millimeters is recommended.
1.
Prepare cables to be attached to a Euroblock plug as shown below.
Be sure to use shielded cable.
CAUTION
Do not tin (plate with solder) the exposed sections of the cable.
WARNING
2.
Loosen terminal screws.
3.
Insert cables.
4.
Securely tighten terminal screws.
Pull the cables (not too strongly) to confirm that they are securely connected.
26
DME64N/DME24N Owner's Manual
Shielded Cable
7mm
30mm
Loosen.
Slotted Screwdriver
Terminal Screw
Euroblock Plug
3mm