Vanguard BHDV37N/P Owner's Operation And Installation Manual page 22

DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
FIREPLACE
INSTALLATION
Continued
REMOVING/REPLACING
GLASS DOOR
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel or without the glass door
panel securely in place. For re-
placement part information see
Replacement Parts , page 33.
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 44).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 45).
4. To replace glass door, follow the above
instructions in reverse.
Top Louver
Panel
Figure 44 - Removing Top Louver Panel
(B)HDV37N/P AND (B)HDV41N/P
®
Screw
Glass Door
Assembly
Figure 45 - Removing/Replacing Glass Door
Attaching Magnetic Decorative
Brass Strips - HDV Only
The HDV fireplaces come with a set of two
magnetic decorative brass strips. Before at-
taching strips to fireplace, remove plastic
film from brass pieces. After installing door,
attach these strips to the top and bottom of
glass door frame.
22
Lower Bracket for
Glass Door Assembly
104558