Advertisement
WIRING INSTRUCTIONS
1. Connect the leads from the amplifier's
outputs to the connector labeled input.
The wires should stay consistent, left +
of the amplifier to left + input of the vol-
ume control, observing polarity and
identification.
CAUTION: Do not reverse the input and
output connections!!
CAUTION: A majority of receivers are
designed to operate at a rating of 8Ω.
On receivers that offer A and B speaker
outputs, both A and B connections share
the same amplifier. It is important to
note, due to the way many receivers are
wired, that when using impedance
matching devices, such as UltraMatch™
volume controls, it is recommended to
wire all speakers to the A output. If you
have any questions contact Russound
directly.
2. As outlined in step #1, connect the
speaker wires to the connector labeled
output.
3. Install the completed assembly in the
junction box. Insert carefully to avoid
excessive strain on the connector. Taking
the time to feed the excess wire out the
back of the junction box will help you
with the final assembly.
6
AMP / Receiver
TO OTHER
VOLUME CONTROLS
SPEAKERS
SPEAKERS
SPEAKERS
SPEAKERS
TO OTHER
VOLUME
CONTROLS
INPUT
OUTPUT
L+
L-
R-
R+
L+
L-
R-
R+
Speaker
Pair
Advertisement
