TP-Link TL-WN321G User Manual page 21

Note:
To build a successful connection by QSS, you should also do the corresponding configuration of
the Access Point for QSS or WPS function
PIN Method
If your Access Point supports Wi-Fi Protected Setup and the PIN method, you can add the
adapter to the network by the following two ways:
1) Enter a PIN from my Access Point
Choose the Config Mode as Registrar and enter the PIN of AP into the field under the Pin Code
as Figure 3-9 shown. And then click PIN button to start the wireless connection without doing any
configuration for AP.
Note:
The default PIN code of the AP always can be found in its label or User Guide.
2) Enter the PIN into my Access Point
Choose the Config Mode as Enrollee and click the PIN button on the screen as Figure 3-10.
Meanwhile, enter the PIN code of the adapter into the configuration utility of the AP. For the
detailed instructions of the AP configuration, please refer to the User Guide of the AP.
TL-WN321G 54M Wireless USB Adapter User Guide
meanwhile.
Figure 3-9 QSS - Registrar mode
Figure 3-10 QSS - enrollee mode
- 16 -