Installing Logs, Lava Rock And Glowing Embers - Desa (V)V42NA(1) Owner's Operation And Installation Manual

FIREPLACE INSTALLATION
24
Installing Optional Brick Liner Models BL42D(S) and BL42DH(S) (Cont.)

Installing Logs, Lava Rock and Glowing Embers

FIREPLACE INSTALLATION
Continued
5. Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 43).
6. Install left side brick panel by sliding it between the grate and
the side of the firebox (see Figure 44).
7. Install the right brick panel using the same method described
in step 6.
8. Replace deflector shield using screws removed in step 4.
9. Follow instructions to install logs, lava rock, and ember material.
10. Close glass door and lock latches on top and bottom of door
and replace screen. See Removing/Replacing Glass Door, steps
5 and 6, page 23.
11. Close top and bottom louvers.
Rear Brick Panel
Figure 43 - Installing Rear Brick Panel
Left Side
Brick Panel
Figure 44 - Installing Left Side and Top Brick Panels
For more information, visit www.desatech.com
For more information, visit www.desatech.com
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass
door. See Removing/Replacing Glass Door, steps 1 and 2 on page 23.
Install logs according to instructions for fireplace model numbers.
1. Place log #1 (base log) onto pin on left front side of grate as
shown in Figure 45.
2. Rest left side of log #2 (front log) onto top of log #1. Place right side
of log onto second pin located on right side of grate (see Figure 46).
3. Place log #3 (rear log) onto pins on rear of grate as shown in
Figure 47.
Figure 45 - Installing Log No. 1
Figure 46 - Installing Log No. 2
Figure 47 - Installing Log No. 3
111906-01A