Desa (V)T32N SERIES Owner's Operation And Installation Manual page 26

FIREPLACE
INSTALLATION
Continued
6. Place log #6 (left log) onto two pins on left
side of back and front log. See Figure 48.
7. Place lava rock along sides and front of firebox
bottom in areas that are visible only. It is not
necessary to use all of lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
8. Pull ember material apart into pieces no larger
than a dime. Place these pieces loosely and
sparingly directly onto exposed section of
front burner and along space between burner
and grate prongs (see Figure 49). This will
create glowing ember appearance as flame
touches ember material. Do not block air slots
by using too much ember material in one area.
It is not necessary to use all of ember material
provided.
Figure 44 - Installing Log No. 1
Figure 45 - Installing Log No. 2
6
9. Close glass door, lock door latches, replace
screen and close louvers (see Removing/Replac-
ing Glass Door, steps 5 through 7, page 24).
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Figure 46 - Installing Log No. 3
Figure 47 - Installing Log No. 4
Figure 48 - Installing Logs No. 5 and No. 6
Ember Material
Figure 49 - Placing Ember Material on
www.desatech.com
WARNING: The glass door
Burner
111986-01D