I/O Port - Sony Ipela NSR-S10 User Manual

6
Click [OK].
Update starts.
Caution
Do not turn off the power while update is in progress.
A message appears when update is complete, and the
unit restarts automatically.
After the unit restarts, confirm whether the firmware
version has been updated in the "System Setting"
screen.
64

I/O Port

I/O Port
Pin Assignment of I/O Port
Audio In/Out
Pin NO. AUDIO
1 AUDIO IN
(used for future expansion)
2 AUDIO IN GND
(used for future expansion)
3 AUDIO OUT
4 AUDIO OUT GND
Sensor In and Relay Out
Pin NO. SENSOR
5 SENSOR IN 1
6 SENSOR IN 1 GND
7 SENSOR IN 2
8 SENSOR IN 2 GND
9 SENSOR IN 3
10 SENSOR IN 3 GND
11 SENSOR IN 4
12 SENSOR IN 4 GND
13 RELAY OUTPUT +
14 RELAY OUTPUT –
Using the I/O Receptacle
Insert a small slotted screwdriver into the upper or lower
slot of the hole you want to connect a wire to (AWG No.
26 to 20). Hold down the screwdriver and insert the wire,
then release the screwdriver.
Caution
Do not use excessive force when inserting the screwdriver
into the slot. Doing so may result in damage.
1
2
Repeat this procedure to connect all required wires.
3