Releasing Alarms; System Administration; Changing The Password - Sony Ipela NSR-S10 User Manual

Releasing Alarms

When an alarm is activated, a warning sound is emitted
from the unit.
In such cases, perform the following to release the alarm
condition and turn off the warning sound.
1
Click (Alarm Status) in the lower right
corner of the "Monitoring (LIVE)" screen.
The "Alarm Status" screen appears.
2
Click [Reset].
The alarm condition is released, and the warning
sound stops.
Caution
• After you perform the above to release an alarm, the
alarm will activate again after one minute if the problem
that triggered the alarm (e.g. an HDD malfunction) has
not been resolved. To prevent the warning sound from
being emitted repeatedly, deselect the [Play Warning
Sound] check box in the "Alarm Setting" Screen
(page 57).
• If the e-mail notification function for alarm occurrences
is enabled, e-mail will be sent once per minute until the
problem that triggered the alarm is resolved. To stop the
sending of e-mail, deselect the [Send E-Mail] check box
in the "Alarm Setting" Screen (page 57).
26
Releasing Alarms / System Administration

System Administration

This section describes how to change the password and
how to check the event log.
For details on other aspects of system administration and
settings, see Chapter 4 "Detailed Descriptions of Settings
and Windows" (page 33).

Changing the Password

You can change the password for logging on to NSR.
Note
The password is extremely important to the security of this
equipment. Be sure to keep the password secure.
1
Click (System Setup) in the lower right
corner of the "Monitoring (LIVE)" screen.
The "Setup" screen appears.
2
Click (User Setting).
The "User Setting" screen appears.