Desa VP10A VN10TA Owner's Operation And Installation Manual page 13

Vent-free gas heater
Table of Contents

Advertisement

OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1.
Remove front panel (see Figure 10, page 7).
2. Follow steps 1 through 5 under Lighting Instructions,
page 12.
3.
With control knob pressed in, strike match. Hold match to
pilot until pilot lights.
4. Keep control knob pressed in for 10 seconds after pilot is
lit. After 10 seconds, release control knob.
5.
Replace front panel.
THERMOSTAT CONTROL BLUE FLAME
AND INFRARED MODELS
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
LIGHTING
INSTRUCTIONS
1.
STOP! Read the safety information above.
2.
Make sure equipment shutoff valve is fully open.
110720-01B
OPERATING HEATER (Manual Control Infrared Models)
OPERATING HEATER (Thermostat Control Blue Flame and Infrared Models)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Manual Lighting Procedure
For Your Safety Read Before Lighting
3. Turn control knob clockwise
(see Figure 22).
4. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP! Fol-
low "B" in the safety information, column 1. If you don't
smell gas, go to the next step.
5. Turn control knob counterclockwise
position. Press in control knob for five (5) seconds
(see Figure 22).
Note: You may be running this heater for the first time
after hooking up to gas supply. If so, the control knob may
need to be pressed in for 30 seconds or more. This will al-
low air to bleed from the gas system.
6.
With control knob pressed in, push down and release igni-
tor button. This will light pilot. The pilot is attached to the
front of burner. The pilot can be seen through the glass panel.
If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, refer to Troubleshooting,
pages 16 through 18. Also contact a qualified service per-
son or gas supplier for repairs. Until repairs are made, light
pilot with match. To light pilot with match, see Manual
Lighting Procedure, page 14.
7. Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob.
• If control knob does not pop up when released, contact a
qualified service person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 3 through 7. This heater
has a safety interlock system. Wait one (1) minute before
lighting pilot again.
8. Turn control knob counterclockwise
heating level. The main burner should light. Set control
knob to any heat level between HI and LO.
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
Ignitor Button
Control Knob
IGNITOR
Figure 22 - Control Knob In
The OFF Position
Lighting Instructions
to the OFF position
Clockwise
to the PILOT
C-clockwise
to desired
C-clockwise
Ignitor Electrode
Thermocouple
Pilot Burner
Figure 23 - Pilot (Infrared Heater
Shown)
13
13

Advertisement

Table of Contents
loading

Table of Contents