Table of Contents
Advertisement
IPv6 Commands
ipv6 rip debug-type
Configures the type of RIPng messages to debug.
ipv6 rip debug-type [error] [warning] [recv] [send] [rdb] [age] [mip] [info] [setup] [time] [tm] [all]
Syntax Definitions
error
warning
recv
send
rdb
age
mip
info
setup
time
tm
all
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
Use the no form of the command to disable a debug type.
•
You can configure more than on debug type in the same command (see example below).
•
Use the
ipv6 rip debug-level
•
all configured types. You cannot set different levels for each type.
Example
-> ipv6 rip debug-type error warning recv send
Release History
Release 5.1.6; command was introduced.
Release 5.1.6.R02 User Guide Supplement
Includes error conditions, failures, processing errors, etc.
Includes general warnings, non-fatal conditions.
Enables debugging in the receive flow path of the code.
Enables debugging in the send flow path of the code.
Debugs RIP database handling.
Debugs code handling database entry aging/timeouts.
Debugs RIPng MIP messages.
Provides general information.
Provides information during initialization.
Debugs timeout handler.
Debugs RIPng Task Manager messages.
Enables all debug options.
command to set the debug level. This command sets the debug level for
June 2005
ipv6 rip debug-type
page 2-71
Advertisement
Table of Contents
