Table of Contents
Advertisement
debug ipv6 packet
direction
output
Defaults
parameter
v6header
extheader
etherheader
raw bytes
board
ether-filter
ipv6-filter
direction
output
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
Use the no form of the command to turn off IPv6 debugging.
•
Options are additive across multiple command lines until reset with the "default" option.
•
Example
-> debug ipv6 packet defaults
Release History
Release 5.1.6; command was introduced.
page 2-22
Allows filtering of packets based on the direction of flow:
all - debug both incoming and outgoing packets
in - debug incoming IPv6 packets
out - debug outgoing packets
from-cmm - debug packets received from the CMM.
from-ipv4 - debug packets received from an IPv4 interface.
to-cmm - debug packets sent to the CMM.
to-ipv4 - debug packets sent to an IPv4 interface.
Specifies the destination for the debug information.
console - write debug information to the console screen or file
file filename - write debug information to the specified file.
default
concise
payload
yes
0
all
no ether-filter
no ipv6-filter
all
console
Release 5.1.6.R02 User Guide Supplement
IPv6 Commands
June 2005
Advertisement
Table of Contents
