Operation - Technics SH-GE70 Operating Instructions Manual

Operation
Technics si.
Equalization-mode indicator Recording mode
selector
1 > 1
~
5 6
To adjust to the desired tone quality
1
Switch the amplifier ON and Reduce the
volume level of the amplifier.
Set the amplifier's tone controls to the centre position, and
set the super bass switch (if equipped) to the off position.
Adjust to the desired sound.
When the equalizer level-control button corresponding to
the frequency to be adjusted is pressed, the equalization
level changes in 2 dB steps.
Set the tape-monitor selector of the amplifier
to "Tape" position. (Refer to note)
(Refer to the operating instructions of the amplifier for
further details.)
Switch ON the power switch.
Press the Input selector button.
source: Set to this position to listen to the radio or a
compact disc, etc.
tape: Set to this position to listen to a tape deck
connected to the back of this unit.
Switch ON the equalization mode-select but-
ton.
(The "EQ on" equalization-mode indicator will illuminate.)
Press the "EQ level" buttons.
(The equalization-level display will appear.)
8
Adjust the volume level of the amplifier.
After completing the adjustment select the desired display
by pressing the display mode-select button: "bar", "dot" or
"peak hold".
Notes:
•To listen or record without the equalization effect, either press the
equalization mode-select button (to the "EQ off" setting) or switch
OFF the power of the graphic equalizer.
• Do not attempt to adjust the equalization level during recording.
Recording mode selector
on: Set to this position to make a tape recording of a radio
broadcast or a disc while controlling the frequency
response.
off: Set to this position to record without equalizer correction.
Note:
The equalization switch must be set to the "on" position and
then the input selector must be set to the "source" position,
otherwise the frequency response cannot be controlled.
This only works for tape decks connected to this unit.
Notes:
•If the amplifier has a recording mode selector and an input selector: (Adjust setting as shown in the figure.)
O O O D ODD D O
(rec selector)
phono or tuner
• If your amplifier has terminals (GRAPHIC EQ/EXTERNAL) for connection of other equipment, use of the recording selector is
unnecessary.
- 7 -