Product Identification; Unpacking; Fundamentals Of Operation - Desa REM30LP Owner's Manual

Desa owner's operation and installation manual propane construction forced air heater blp30,rem30lp
Hide thumbs Also See for REM30LP:
Table of Contents

Advertisement

SAFETY INFORMATION
Continued
• Keep heater away from strong drafts, water spray, rain, or drip-
ping water.
• Do not leave heater unattended.
• Keep children and animals away from heater.
• Never move, handle, or service a hot, operating, or plugged-in
heater. Severe burns may result. You must wait 15 minutes after
turning heater off.
• To prevent injury, wear gloves when handling heater.
• Never attach duct work to front or rear of heater.
• Do not alter heater. Keep heater in its original state.
• Do not use heater if altered.
• Turn off propane supply and unplug heater when not in use.
• Use only original replacement parts. This heater must use de-
sign-specific parts. Do not substitute or use generic parts. Im-
proper replacement parts could cause serious or fatal injuries.

PRODUCT IDENTIFICATION

Hot Air Outlet
(Front)
Piezo
Ignitor
Button
Automatic
Control Valve
Button
Figure 1 - 30,000 BTU/Hr Model
For more information, visit www.desatech.com
For more information, visit www.desatech.com
104163-01H
Outer Shell
Handle
Motor
Power Cord
Hose/Regulator
Assembly
PRODUCT IDENTIFICATION

FUNDAMENTALS OF OPERATION

UNPACKING

1. Remove all packing items applied to heater for shipment. Keep
plastic cover caps (attached to inlet connector and hose/regu-
lator assembly) for storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
FUNDAMENTALS OF
OPERATION
The Fuel System:
The hose/regulator assembly attaches to the
propane gas supply. This provides fuel to the heater.
The Air System:
The motor turns the fan. The fan pushes air into and
around the combustion chamber. This air is heated and provides a
stream of clean, hot air.
The Ignition System:
The piezo ignitor lights the burner.
The Automatic Control System:
shut down if the flame goes out.
Clean
Heated Air
Out (Front)
Combustion
Chamber
Air For Combustion
Figure 2 - Cross Section Operational View
SAFETY INFORMATION
UNPACKING
This system causes the heater to
Fan
Motor
Air For Heating
Hose/Regulator
Assembly
3 3
Cool Air In
(Back)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Blp30

Table of Contents