Desa HRB3624 Owner's Operation And Installation Manual page 17

INSTALLATION
Continued
Propane/LP
Supply Tank
Figure 18 - Checking Gas Joints
(Propane/LP Only)
Gas Meter
Figure 19 - Checking Gas Joints (Natural
Gas Only)
INSTALLING OPTIONAL REMOTE
ACCESSORIES
Installing Remote Receiver
Remote control accessories are available sepa-
rately (see Accessories, page 42).
1. If unit is already installed in fireplace, continue
with these instructions. If unit has not been
installed in fireplace, go to step 6 and continue
installation of remote accessory.
WARNING: Turn off heater
and let cool before handling any
part of heater. Make sure gas is
turned of to unit.
2. Carefully remove logs and set aside.
3. Locate mounting screws on sides of heater
base assembly and remove screws. Set screws
aside for reinstallation.
119426-01A
Equipment
Shutoff Valve
Thermostat Gas
Valve or Control
Valve Location
Equipment
Shutoff Valve
Thermostat Gas
Valve or Control
Valve Location
www.desatech.com
4. Disconnect gas line from heater base as shown
in Figure 11 or 12, page 13.
WARNING: A qualified ser-
vice person must connect and
disconnect gas to heater. Follow
all local codes.
5. Remove heater base from fireplace.
6. Install receiver bracket to base with phillips
screws provided in hardware kit as shown in
Figure 20.
7. Disconnect jumper wire from control valve at
TPTH and TH locations (see Figure 21).
8. Install remote receiver into receiver bracket
using pads and push button clips provided
with receiver (see Figure 22).
Phillips
Screws
Remote Receiver Bracket
Figure 20 - Installing Remote Receiver
Bracket
Control Valve
Figure 21 - Disconnecting Jumper Wire
From Control Valve
Push
Button
Bracket
Clips
Figure 22 - Installing Remote Receiver
Jumper
Wire
9-Volt Battery
Battery
Clip
Pad
Terminal
Wires
17