Table of Contents
Advertisement
4.
Enter the series of commands you want the macro to execute (up to 15 commands).
5.
Press and hold SET until the red LED blinks twice, and then release.
Now, when you press the preset macro key , the remote sends the series of commands you have entered, regardless of what mode you are in.
For example, you could program a macro key to turn on both your TV and cable box and select a particular channel.
To clear the macro, repeated steps 1-5 above, but do not enter a series of commands at step 4.
Programming a Mode-Dependent Macro
1.
Press the device mode key (TV, DVD, STB, or AUX).
2.
Press and hold SET until the LED blinks twice, then release.
3.
Press 9 7 8. The LED blinks twice.
4.
Press the key you wish to assign a macro on.
5.
Enter the series of commands you want the macro to execute (up to 15 commands).
6.
Press and hold SET until the red LED blinks twice, and then release.
Now, when you press the macro key, the remote sends the series of commands you have entered, but only if you are in the mode you selected in
step 1. For example, you could program the macro key to turn on both your TV and cable box and select a particular channel, but only if you are
in TV mode. If you are in DVD mode, this key does not execute the macro you set up in TV mode.To clear the macro, repeat steps 1-6 above, but
do not enter a series of commands at step 5.
TROUBLESHOOTING
PROBLEM
LED does not blink when you press a key.
LED blinks when you press a key, but device does not respond.
LED blinks one long blink while in SET mode.
Remote does not control devices or commands are not working
properly.
No volume on a device.
Channels do not change properly when directly entering digits to
change channels.
SOLUTION
Try pressing different keys. Replace the batteries with 2 new AA
batteries.
Make sure the remote is aimed at your device and is not more than 40
feet away.
An entry error has occurred (for example, wrong key). Try entering the
sequence again.
Try all listed codes for the device. Make sure the device operates with an
infrared remote control.
See "Changing Volume Lock" and make sure the volume is not locked to
a different mode already.
If the original remote control required you to press Enter to change
channels, press Enter on this remote after entering the channel number.
43
Advertisement
Table of Contents
