Viking RDIPR101RSS Use & Care Information Manual page 6

viking range corporation
prepare tHe DoWnDraFt
Exterior Blower Installation
The downdraft is shipped without a blower. Purchase a Model
VEDV900 Exterior Blower and mount the 10" discharge plate
to the downdraft as follows:
1. Place the downdraft on its back on a table of flat work surface.
2. Remove the 4 nuts and 2 clamp channels.
3. Remove 2 screws and the gear motor cover.
4. Carefully position the10" discharge plate under the bottom
flange of the downdraft.
5. Connect motor plug.
6. Replace the gear motor cover and 2 sheet metal screws.
7. Replace the 2 clamp channels and start the 4 nuts, do not
tighten.
8. Slide blower left of right to desired position. Use cover plate
(supplied) to close up any open space.
9. Tighten 4 nuts to secure top of blower. Use additional screws
(supplied) through bottom flange to secure bottom of discharge
plate.
cUt coUntertop opening
All Units
Cooktop Width & Model
For use with Downdraft Models
Cutout Dimensions A
B
C
D
E
F
E
30" RDECU206
30" RDGSU200
RDIPR101RSS
29-1/8"
20-5/8"
27"
2-1/4"
1-1/16"
1-1/16"
F
C
B
A
CLAMP
CHANNELS
SCREWS
GEARMOTOR
COVER
1. Measure and cut the countertop opening for your width of
cooktop and downdraft.
36" RDECU266 45" RDECU256
36" RDGSU260
RDIPR161RSS RDIPR151RSS
34-7/8" 42-7/8"
20-5/8" 20-5/8"
33" 42"
2-1/4" 2-1/4"
15/16" 7/16"
15/16" 7/16"
D
BLOWER MODEL
VIDV500
VEDV900
VEDV1200
6
D3 Downdraft Ventilators
MOTOR
PLUG
NUTS
BOTTOM
FLANGE
DIMENSIONS
18.25" x 18.214" x 7.569"
28.25" x 24.75" x 7.16"
22" x 30.828" x 12.724"
10" ROUND
DISCHARGE
PLATE
COVER
PLATE
ADDITIONAL
SCREWS