Separating Bearing Housings
1.
Select the proper size Bearing Separator Jaw (2.2"~3.0" # 2 or 2" # 14) for the
bearing size being separated. Refer to the illustration below.
2.
Loosen the Separator Jaw Nuts (3) sufficiently to allow the jaws to catch
between each bearing housing.
3.
Using a wrench (not supplied) begin to tighten Nuts (3) until the jaws are
securely set between the bearing housings.
4.
Screw in the selected Extension Screws (5" - 4 and 12, or 4" - 6 and 9) as
shown below.
The Extension Screws allows the user to grip them and add stability while
tightening Nuts (3).
5.
Continue tightening Nuts (3) until the bearing housings are separated.
When the bearing housings are separated, remove the Bearing Separator
Jaw.
Caution: Overtightening Separator Jaw Nuts may damage bearings.
Bearing Separator
Jaw (2.2"~3.0" # 2
or 2" # 14)
Bearing Housing
Nuts (3)
1.
Wipe off components of the Bearing Separator Set of all grease and dirt.
2.
Store all components in the plastic Case, and place in a clean and dry
location.
SKU 93980
Maintenance
For technical questions, please call 1-800-444-3353
Extension Screws
Extension Screws
Page 5