Advertisement
13.
Only use Carrier with a properly
installed Class iii or Class iV 2 inch
hitch receiver capable of supporting
the Carrier and its load.
14.
The warnings, precautions, and in-
structions discussed in this instruction
manual cannot cover all possible con-
ditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SaVe tHeSe
inStRuCtionS.
pRoduCt SpeCiFiCationS
Maximum
500 Pounds
Weight Capacity
Heavy-duty tubular steel
Construction
construction.
2" (Vehicle hitch requires
Vehicle Hitch
a Class III or Class IV tow
Receiver Size
rating.)
Hitch Pin Size
5/8" dia. (with clip)
unpaCKinG
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
SKU 66983
For technical questions, please call 1-800-444-3353.
aSSeMbly inStRuCtionS
Read the entiRe iMpoRtant
SaFety inFoRMation section
at the beginning of this manual
including all text under
subheadings therein before
assembly of this product.
For reference, please refer to the as-
sembly diagram on page 6:
1.
Align the mounting holes on ends of
the Right Frame (2) and Left Frame
(3) with the mounting holes along the
sides of the Post (1).
2.
With a wrench (not included), fasten
the Frames to the Post by using the
Connecting Bolts (10) and the Flat
Washers (11), Spring Washers (12)
and Nuts (13). See assembly dia-
gram on page 6.
3.
Set the Cross Braces (6) over the
Frames (2,3) and fasten the Cross
Braces to the Frames by using the
Bolts (7), Flat Washers (8), and Lock
Nuts (9). See assembly diagram
on page 6.
4.
Make sure all connections are tight-
ened securely.
opeRatinG inStRuCtionS
Read the entiRe iMpoRtant
SaFety inFoRMation section
at the beginning of this manual
including all text under
subheadings therein before use
of this product.
Page 4
Advertisement
