Denon AVR-5800 Operating Instructions Manual page 34

3 Select the play mode.
Example: Stereo
STEREO
(Main unit)
4 Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
5 Adjust the volume.
The volume level is
displayed on the
master volume level
display.
The volume can be adjusted within the range of –60 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 25 or page 42, if the volume for any channel is
set at +1 dB or greater, the volume cannot be adjusted up to 18
dB. (In this case the maximum volume adjustment range is "18 dB
— (Maximum value of channel level)".)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to "AUTO" or "DTS".
NOTE:
• The digital input indicator will light (green) when playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the Direct or Home THX Cinema mode.
1 Press the MODE SELECT button and select
TONE.
The mode switches as follows each time
the MODE SELECT button is pressed:
Only displayed when the TUNER input is
selected.
2 Select BASS/TREBLE with the
FUNCTION knob.
34
(Remote control unit)
MASTER VOLUME
(Main unit) (Remote control unit)
MODE
SELECT
(Main unit)
FUNCTION
(Main unit)
Input mode display
• In the AUTO mode
INPUT MODE
PCM RF
AUTO DTS
• In the PCM mode
INPUT MODE
AUTO PCM DTS RF
• In the DTS mode
INPUT MODE
PCM RF
AUTO DTS
• When switched to RF in the VDP RF or AUTO mode
INPUT MODE
PCM RF
AUTO DTS
• In the ANALOG mode
INPUT MODE
PCM RF
AUTO DTS
Input signal display
One of these lights, depending on the
input signal.
• DOLBY DIGITAL
INPUTSIGNAL
LOCK DIGITAL
• DTS
INPUTSIGNAL
LOCK DIGITAL
• PCM
INPUTSIGNAL
LOCK DIGITAL AL24
The AL24 indicator lights when the PURE DIRECT, DIRECT or
STEREO mode is selected in the digital input mode.
The LOCK LED lights when digital signals are being input properly.
If the LED does not light, check whether the digital input
component setup (page 28) and connections are correct and
whether the component's power is turned on.
One of these lights, depending on the
input signal.
ANALOG DIGITAL
DIGITAL
DIGITAL
DIGITAL
ANALOG
PRO LOGIC
4 1 2 3