McAfee VIRUSSCAN 5.1 Getting Started Manual page 30

Removing Infections From Your System
If VirusScan software found an infection during installation, follow these
steps carefully:
1. Quit Setup immediately, then shut down your computer.
2. If you created a VirusScan Emergency Disk during installation, or if your
3. Wait at least 15 seconds, then start your computer again.
4. Type y to continue, then skip to Step 7. If you did not, type n, then turn
5. Read the notice shown on your screen, then press any key on your
30 McAfee VirusScan
Be sure to turn the power to your system off completely. Do not press
CTRL+ALT+DEL or reset your computer to restart your system—some
viruses can remain intact during this type of "warm" reboot.
VirusScan copy came with one, lock the disk, then insert it into your
floppy drive.
Š NOTE: If your VirusScan software copy did not come with an
Emergency Disk, or if you could not create an Emergency Disk
during Setup, you must create a disk on an uninfected computer.
Locate a computer that you know is virus-free, then follow the steps
outlined in "Using the Emergency Disk Creation utility" on page 49
of the VirusScan User's Guide.
Š NOTE: If you have your computer's BIOS configured to look for its
boot code first on your C: drive, you should change your BIOS
settings so that your computer looks first on your A: or B: drive.
Consult your hardware documentation to learn how to configure
your BIOS settings.
After it starts your computer, the Emergency Disk runs a batch file that
leads you through an emergency scan operation. The batch file first asks
you whether you cycled the power on your computer.
your computer completely off and begin again.
The batch file next tells you that it will start a scan operation.
keyboard to continue.
The Emergency Disk will load the files it needs into memory. If you have
extended memory on your computer, it will load its database files into
that memory for faster execution.