Brother GT-341 Instruction Manual page 144

7. Troubleshooting
Error
Message
code
5406
5411
Machine Error
5312
5413
5314
5421
Machine Error
5422
5431
5432
Machine Error
5433
5434
5435
5441
Machine Error
5442
5443
5451
Machine Error
5452
5453
5454
5455
Machine Error
5456
5457
Machine Error
5458
5471
5472
5473
5474
Machine Error
5475
5476
5477
5478
134
Meaning
Communication error between Main
PCB and Maintenance Unit
Failure of moving Pump in the
Maintenance Unit
Failure of moving Caps in the
Maintenance Unit
Failure of moving Wipers in the
Maintenance Unit
Internal error of Maintenance Unit
caused by firmware update
Communication error between Main
PCB and the Maintenance Unit caused
by firmware update
Internal error of Maintenance Unit
caused by firmware update
Communication error between
Maintenance Unit and Ink Sensor PCB
GT-3 Series
Solution
Confirm if there is any device around GT-3 that makes
strong noise. Move GT-3 from that device.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.
Confirm if the Wiper Cleaners and Wiper Blades are
properly mounted in the Maintenance Unit. Confirm that
something may prevent the Caps moving up and down.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.
Confirm if the Wiper Cleaners and Wiper Blades are
properly mounted in the Maintenance Unit. Confirm that
something may prevent the Caps and Wipers moving.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.
Confirm if there is any device around GT-3 that makes
strong noise. Move GT-3 from that device.
Reboot GT-3 and re-upgrade the firmware.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.
Confirm if there is any device around GT-3 that makes
strong noise. Move GT-3 from that device.
Contact your dealer or Brother when the issue was not
solve after you rebooted GT-3.