Last Function Memory; Initialization Of The Microprocessor - Denon AVR-5700 Operating Instructions Manual

Recalling preset stations
1 Watching the display, press the SHIFT button to select the
preset memory block.
SHIFT
(Main unit)
2 Watching the display, press the PRESET UP or DOWN
button to select the desired preset channel.
DOWN UP
(Main unit)

13 LAST FUNCTION MEMORY

• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit's
power switch is off and with the power cord disconnected.

14 INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the
microprocessor is required by the following procedure.
1
Switch off the unit using the main unit's power switch.
2
Hold the following DIRECT button and STEREO button, and
turn the main unit's power switch on.
Check that the entire display is flashing with an interval of
3
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
54
SHIFT
(Remote control unit)
CHANNEL
(Remote control unit)
1 2
RC-853
START LEARNED/TX
SYSTEM CALL POWER
SET CALL OFF ON / SOURCE
DVD VDP TUNER SHIFT
1 2 3
TV/DBS V.AUX PHONO
4 5 6
VCR-1 CD MD / TAPE-1 CHANNEL
7 8 9
VCR-2 TAPE-2 MON
TV/VCR
+10 0
A / B
VOLUME DISC SKIP+
DOLBY / DTS
1,2
2
Lightly press on the button
of the door to open it.
1
2