Vcr Setup - LG 42PX5D - 42 Plasma Integrated HDTV Owner's Manual

Installation
3. Anamog and Digitat TV signals provided on cable and antenna
f
Antenna
Cable TV Wall
Jack
Bronze Wire
Turn clockwise to tighten.
RF Coaxial Wire (75 ohm)
Bronze Wire
_J
• To improve the picture quality in a poor signal area,
please purchase a signal amplifier and install properly.
• If the antenna needs to be split for two TV's, install a "2-
Way Signal Splitter" in the connections.
If the antenna is not installed properly, contact your deal-
er for assistance.
- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Use the ISM Method (on the Option menu) feature to avoid having a fixed image remain on the screen for a long period of time.
If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.
Connection Option 1
Set VCR output switch to channel 3 or 4 and
then tune the TV to the same channel number.
Connection Option 2
1. Connect the audio and video cables from the
VCR's output iacks to the TV input jacks, as
shown in the figure.
When connecting the TV to VCR, match the
iack colors (Video = yellow, Audio Left = white,
and Audio Right = red).
If you connect an S-VIDEO output from VCR to
the S-VDEO input, the picture quality is
improved; compared to connecting a regular
VCR to the Video input.
2= insert a video tape into the VCR and press
PLAY on the VCR. (Refer to the VCR owner's
manual.)
3= Select the input source with using the
TV/WDEO button on the remote control. Note
that this TV finds the connected input sources
automatically for Video, Front Video and
Component 1-2. It is presumed that RGB,
HDMI1/DVl and HDM!2 sources are connected.
Do not connect to both Video and
S-Video at the same time.
Owner's Manual 15