Table of Contents
Advertisement
INSTALLATION - Bracket
You can install the SupraPro I.D. on the top of a dash or from an overhead
with the supplied bracket. It can also be installed in the dash with an
optional IDA-3 mounting kit. If you use the supplied bracket, you may be
interested in the optional GBSA-1 swivel bracket kit. This converts the
SupraPro I.D.'s gimbal bracket to a swivel mount which can be used on the
dash mounting position. Installation instructions for the in-dash and swivel
mounting kits are supplied with the adapter kits.
Mount the SupraPro I.D. in any convenient location, provided there is
clearance when it's tilted for the best viewing angle. Holes in the bracket's
base allow wood screw or through bolt mounting. It may be necessary to
place a piece of plywood on the back side of thin panels to reinforce the
panel. Make certain there is enough room behind the unit to attach the
power and transducer cables.
Drill a hole in the dash for the power and transducer cables. The best
location for this hole is immediately under the gimbal bracket. This way, the
bracket covers the hole. The smallest hole the power and transducer cable
connector can pass through is 5/8". INSTALL THE TRANSDUCER FIRST!
Then route the cable from the transducer to the unit by passing the power
and transducer cables through the hole from under the dash. Slide the
bracket over the hole, then route the transducer and power cables out the
slot in the back of the bracket. Finally, fasten the bracket to the dash.
Attach the SupraPro I.D. to the gimbal bracket using the supplied gimbal
knobs and washers as shown above.
SUPRAPRO I.D.
GIMBAL BRACKET
THICK WASHER
(PORTABLE UNITS
4
THIN WASHER
ONLY!)
GIMBAL KNOB
Hide quick links:
Advertisement
Table of Contents
