Lexicon PCM 91 - REV User Manual page 52

PCM 91 User Guide
2-30
Modifying the Soft Row, or creating a completely new Soft Row for an effect is
easy:
1. From the full Edit matrix, press Up until you get to the Soft Row, indicated by
an S in the lower left corner of the display.
2. With any Soft Row parameter displayed, press and hold down the Edit
button. The following display will appear briefly.
Entering Soft Row
assign . . .
When you release the Edit button, the display will change to the Soft Row
Assignment display shown below. The Edit button LED will begin flashing
and will continue to flash as long as you are in Soft Row Assign.
Soft Row param :
Controls Mix
Here we show the first Soft Row parameter in our example — the actual Soft
Row parameter selected will correspond to whichever one was displayed
when you pressed and held Edit.
3. Turn ADJUST to scroll through all of the available parameters in the Edit
matrix row by row, in numerical order. The entry "available" can be selected
(at the fully counterclockwise position of ADJUST) to indicate that no
assignment has been made at that position. Custom Controls are available
for assignment at the end of the parameter list.
4. Turn SELECT to display another Soft Row position (0-9) for assignment. For
each position, you can choose any effect parameter, including one(s) you
have already assigned to a Soft Row position.
5. When you have arranged the Soft Row assignments as you want them,
press Edit to exit Soft Row Assign and return to your last position in the Edit
matrix. Pressing Up or Down once will also cause you to exit Soft Row
Assign. Another push of either of these buttons will move you vertically
through the Edit matrix.
When you return to Go mode, you will see the parameters in the order you
assigned them — the spaces from any unassigned row positions will not appear.
0
Lexicon