Info; History Of Effects Loaded - Lexicon PCM 91 - REV User Manual

The PCM 91 offers an extensive set of informative display messages which can
be activated from the front panel.
The front panel switches perform various functions when pressed. Most of these
functions are activated on release of the button. If you want to know more about
the function of a particular button (without actually executing any action) press
and hold the button down. While you are holding down the button, an explanatory
message will appear on the display. The activation of an Info message overrides
the normal function of the button, so that no action is taken on release.
Info messages are displayed when a button is pressed and
held down. Generally, Info messages inform you of the
function of a button, or provide current status information.
Displays the current function
assigned to the Up button and
the ADJUST knob.
Displays the current function
assigned to the Down button
and the SELECT knob.
The PCM 91 allows you to review the last ten effects loaded. This is useful when
you want to return to an effect you were using earlier, but can't remember its
name or location. This History view is accessed from Program Banks or Register
Banks mode by simultaneously pressing and releasing both the Program
Banks and the Register Banks buttons. The following display will appear:
The top line of the display
shows the position in the review
list of the displayed effect.
The label 1 back in the example, means that the effect shown on the bottom line
was running just before the current effect. Turning SELECT to the right will scroll
you through the stored list of effects, all the way to 10 back. Press Load/ to load
any of the displayed programs. Press any key to exit.
Note that loading programs from the review display does not update the
historical record, nor does loading from MIDI, Chain or Map. Only program loads
from Programs Banks or Register Banks mode are recorded.
Displays the currently loaded effect name,bank, and matrix
location. In Program Banks or Register Banks mode,
simultaneously press and release both buttons to display
the last ten effects loaded.
Displays action needed to
perform a store operation or
Memory Protect message when
store function is disabled.
History: 1 back
XX X.X XXXXXXXXXX
Inactive until an effect has been
altered, then displays "Press to
hear stored effect"
The bottom line shows the
bank and matrix location and
the name of the effect.
Basic Operation

Info

Displays the current tempo and
the clock source (MIDI or
Internal).
Displays the type of system
bypass currently selected,
and the current status (on
or off).

History of Effects Loaded

2-3