Table of Contents
Advertisement
OMEGA
™
USING ThE lExICON OMEGA™ STUdIO
SECTION I – RECORDING WITH THE OMEGA
Let's see how to use the Omega Studio in some typical recording situations. The diagram
below shows how the Omega Studio is connected for this particular setup.
A. RECORDING A MICROPHONE INPUT
1. Plug your microphone cable into the Mic 1 XLR jack on the
back of the Omega. If the mic needs phantom power, push the
+48 V switch (located just above the POWER input) in.
2. Now we need to set up the Omega to record from the Mic 1 input. On the front
of the Omega locate the
knobs. Press the USB Assign button until the 1-2 led is lit red. This means we
are now streaming audio to the computer via the USB 1-2 input drivers from the
Microphone Jacks. Next, press in the
it is in the
position. Since we are recording only one microphone right now
MONO
we will want to be able to hear it on both sides of our headphones.
(Lit when using USB 1-2)
USB Assign Button
V
button between the Mic 1 and Mic 2 Gain
USB ASSIGN
MONITOR
(Lit when using USB 3-4)
Recording With The Omega - Section 1
TM
XLR Jack
button between Mic 1 and Mic 2 so
Monitor Button
17
Advertisement
Table of Contents
