Lexicon MPX 1 V1.10 - MIDI IMPLEMENTATION DETAILS Midi Implementation Manual page 46

Lexicon
MIDI Receive Channel (midi_in_channel)
This is the MIDI channel on which the system recognizes incoming data. Legal values are 0-15 for the
standard midi channels, 16 for MIDI off and 17 for Omni mode.
MIDI Transmit Speed (midi_output_rate )
This sets the rate at which midi data is output from the system. Only the values in the following table should
be used in this field:
Fast
Medium Fast
Medium Slow
Slow
MIDI SysEx Receive (midi_device_id)
This is the device ID used in all outgoing SysEx dump messages and incoming messages. Legal values
are 0-126.
MIDI SysEx On/Off (sysex_on_off)
This enables (1) or disables reception of SysEx data by the system.
MIDI Transmit (midi_out_channel)
This is the MIDI channel on which the system outputs MIDI data. Legal values are 0-15 for the standard
midi channels and 16 for MIDI off.
Pgm# Offset (program_change_offset)
This 2 byte value sets the "Pgm# Offset" on the system which allows incoming standard program change
messages to be offset from the first program. Normally a program change value of 0 loads program 1.
MIDI Automation (midi_automation_mode)
This determines if the MIDI automation in the system is on (1) or off (0).
MIDI Clock Send On/Off (midi_clock_mode)
This determines if MIDI clock is (1) or is not (0) to be transmitted from the system (MIDI out).
Program Sort Mode (sort_mode)
This sets the current program sort mode in the system. The following values have been defined:
SORT_BY_NAME
SORT_BY_NUMBER
SORT_BY_INPUT
SORT_BY_FX_TYPE
SORT_BY_INP_AND_FX
SORT_BY_MIDI_MAPS
SORT_BY_MIDI_CHAINS
SORT_BY_TOP_10
Modes Contrast (cur_contrast)
This sets the contrast level of the system's LCD. Legal values are 0-15.
Automation Xmit ID (automation_device_id)
This sets the device ID of the outgoing SysEx data generated by the system's automation. Legal values
are 0-126 or 127 for all targets. (this is an option of the MIDI Automation On/Off)
MIDI Pgm Change On/Off (program_change_mode)
This enables (1) or disables (0) program changes via standard MIDI program change messages.
MIDI Ctl Smooth (cont_smooth)
This sets the amount of interpolation that is performed on the incoming MIDI controller data. 0 = no
interpolation, 100 = full interpolation.
- 0x01
- 0x02
- 0x04
- 0x40
0
1
2
3
4
5
6
7
MPX 1 V1.10 MIDI Implementation Details
43